Introduction: Diagnostic Reference Levels (DRLs), typically set at the 75th percentile of the dose distribution from surveys conducted across a broad user base using a specified dose-measurement protocol, are recommended for radiological examinations. There is a need to develop and implement DRLs as a standardisation and optimisation tool for the radiological protection of patients at Computed Tomography (CT) facilities. Methods: This was a retrospective cross-sectional study conducted in seven (7) different CT scan facilities in which participants were recruited by systematic random sampling. The study variables were dose length product (DLP) and volume-weighted CTDI (CTDIvol) for the radiation doses for head, chest, abdomen and lumbar spine CT examinations. The DRLs for CTDIvol and DLP were obtained by calculating the 3rd quartiles of the radiation doses per study site by anatomical region. The national diagnostic reference levels were determined by computation of DRLs using the 75th centile of the median values. Results: A total of 574 patients were examined with an average age of 47.1 years. For CTDIvol estimates; there was a strong positive significant relationship between the CTDIvol and examination mAs (rs = 0.9017, p-value < 0.001), and reference mAs (rs = 0.0.7708, p-value < 0.001). For DLP estimates; there was a moderate positive significant relationships between DLP and total mAs (rs = 0.6812, p-value < 0.001), reference mAs (rs = 0.5493, p-value < 0.001). The DRLs were as follows; for head CT scan – the average median CTDIvol was 56.02 mGy and the DLP was 1260.3 mGy.cm; for Chest CT, the CTDI volume was 7.82 mGy and the DLP was 377.0 mGy.cm; for the abdomen CT, the CTDI volume 12.54 mGy and DLP 1418.3 mGy.cm and for the lumbar spine 19.48 mGy and the DLP was 843 mGy.cm, respectively. Conclusion: This study confirmed the need to optimize the CT scan parameters in order to lower the national DRLs. This can be achieved by extensive training of all the CT scan radiographers on optimizing the CT scan acquisition parameters. Continuous dose audits are also advised with new equipment or after every three years to ensure that values out of range are either justified or further investigated.
Loading....